Hello everyone lovers mastery homemade cars From existing parts from broken machines! Today we will tell you how to independently make a typewriter on a motor.

This model of the toy car is an aeromobile (structurally similar to ""), that is, it will be driven by the screw. If you wish, it can be put into the boat, which is very quickly floating.

Mastery machine on a motor

To create an Aerobil, you will need the following details:

If you are ready, we start to make it!

  1. Squash to wire batteries and connect them successively, that is, "+" one battery solder to "-" the second and so on.

    Connect batteries by creating a sequential electrical panel

    Crerate them with Rubber Rings. Thus, you should turn out a 6 volt battery.

    Finger batteries connected by rubber rings

    Alternatively, you can replace your finger batteries on one or two more powerful, then to solder or do not have to, or will need less.

  2. Connect the toggle switch to batteries, and then connect the electromotor to this electrocuprup. Including - turning off the toggle switch, check if the motor works.

    Connect the electric motor to the battery

  3. After moving to the creation of the body of the machine. To do this, cut the rectangular base of the machine and mark the location of the wheels.

    Cut the body of the machine

  4. Make a knife in the foam on the thickness of the tubes, put on the axis of the wheels.

    Prepare wheel mounts

  5. Cut from the foam two thin plates that will fix the wheels. Screw them with screws.

    Fasten the wheel screws

  6. Cut the fastening for the electric motor and secure it on the base of the typewriter.

    Cut mount for a motor

  7. Attach the electromotor to it using a rubber and thin hairpin or nail, as shown in the figure.

    Attach the electric motor

  8. Cut the screw from the plastic bottle. Injust its blades. Make a hole in the center and insert the screw on the electromotor, securing it with a locking ring from the ballpoint rod.